Specifically designed to bond to acoustic foam and EPS.
GlueArt 3.0 is a polymer-based glue, specifically designed to bond to acoustic foam and EPS. It is applicable on a vast range of surfaces, including cement, painted surfaces, stone, wallpaper, plasterboard, wood, chipboard, PVC, expanded plastic, mineral fibres and metal.
GlueArt 3.0 is especially easy to use, gluing lighter panels such as Myron E practically instantly. Heavier panels, although requiring initial support, start to bond after just 10 minutes, bonding with a safety factor of over 10.
GlueArt is made from E-SBR, and specifically designed to bond our acoustic panels. SBR (styrene-butadiene rubber) is a polymer with superior adhesive efficiency; in comparison with other products on the market it presents a higher durability, reduced shrinkage, increased flexibility and is resistant to emulsification in damp conditions.
GlueArt 3.0
Installation Procedure:
1. The surface must be clean, dry, and free of grease.
2. Apply the adhesive to the back of the panel with a sealant gun. If applying to an extremely irregular surface, apply adhesive to both the panel and the target surface.
3. Place the panel on the wall in the correct position and apply pressure.Install the panel within 10 minutes after applying the glue. Heavier panels require additional support until the adhesive has cured.
Avoid making any adjustments to the panel after gluing, as this may reduce the glue force. The cure time depends on the layer thickness, temperature, and air humidity.-
Make sure the target area is dry, has a stable finish, and is free of dust and grease. We recommend cleaning with a wire brush before starting.
Glueart can be used on bare cement, painted surfaces, stone, wallpaper, plasterboard, wood, chipboard, PVC, expanded plastic, mineral fibres and metal.
One Tube installs either 8 flat foam panels (Agad, Thor, Myron E, etc.) or 8 nestled foam panels (framed absorbers).